A large 2 line display uses 3/4” digits to communicate the measurements to you.

AC and DC volts from 1 milliVolt to over 200 Volts are measured using 4 different ranges. The Ohms function measures from a tenth of an ohm to 40 million Ohms.

Measure up to 10,000 RPM on 2 or 4 cycle engines.

Measure from 10 milliamps to 20 Amps. Use the low amps probe to find parasite draw, measure fuel injector amperage, fuel pump draw, ignition coil current, or any other current less than 20 Amps. There is no danger of over ranging the unit and blowing the fuse.

Measure from a tenth of an amp to 600 amps. Use the high amp probe to measure Starter Draw, Alternator Output, or any amperage draw larger than .1 amps.

The coil function measures Peak Amps and Build time for fuel injectors and ignition coils.

The Fuel test is an industry exclusive way to test and measure the performance of any electronic fuel pump. Measures the RPM, Amperage, and Peak Amperage of the Fuel Pump.

Using a unique system of LED’s, the function buttons will illuminate to indicate which function is selected. The keys are laid out in an ergonomic fashion for ease of use.